Alarm: Low voltage, Counting value composition error, Over-flow error, Tolerance limit setting error.Origin-set/Preset, Zero set, GO/±NG judgment, Power ON/OFF, Data output, inch/mm conversion (on inch/metric models only).Length standard: ABSOLUTE electrostatic capacitance type linear encoder.The Mitutoyo 543-266B can be used with other brands but is the recommended electronic indicator to be used with Mitutoyo Bore Gages. Employing the ABSOLUTE linear encoder, the Signal ID-C always displays the spindle absolute Position” from the origin at power-on.3 references which will hold three presets into the electronics.Go and No-Go tolerances can be set with upper and lower limits.An analog bar indicator is displayed on the top of the readout. ![]() The minimum value holding function provides the easy of detection of bore diameter.The Mitutoyo 543-266B absolute digimatic indicator for bore gages has the following specifications: The Mitutoyo 543-266B Absolute Digimatic Indicator ID-C Bore Gage Type has now been discontinued and replaced by the new Mitutoyo Digimatic Indicator for Bore Gages Type: 543-312B.ĥ43-266B Mitutoyo ABSOLUTE Digimatic ID-C Series for Bore Gages: 0-.500″/12.7mm
0 Comments
Leave a Reply. |